skyblue Posted October 24, 2014 Report Share Posted October 24, 2014 How was barbies bar after words.lol I heard Ken showed up hammered and started to get all coyote ugly on the bar. 2 Quote Link to comment
edekalil Posted October 24, 2014 Report Share Posted October 24, 2014 Ordered some of these from Napa. Quote Link to comment
edekalil Posted October 25, 2014 Report Share Posted October 25, 2014 Ordered some of these from Napa.Picked up the others I ordered this mornning. Quote Link to comment
r0p0doe Posted October 26, 2014 Report Share Posted October 26, 2014 How was barbies bar after words.lol I heard Ken showed up hammered and started to get all coyote ugly on the bar. Not my kind of bar, music wasn't in an language I understand and i'm sure I would of gotten dirty looks if I went in tanker lol 1 Quote Link to comment
mrbigtanker Posted October 26, 2014 Report Share Posted October 26, 2014 Hill billy bar I presume. Just tell them your Darius Ruckers younger brother..whooooo yee haw..lol May be next time. 1 Quote Link to comment
r0p0doe Posted October 26, 2014 Report Share Posted October 26, 2014 Hill billy bar I presume. Just tell them your Darius Ruckers younger brother..whooooo yee haw..lol May be next time. No it was a "pisa" bar, although I do understand some spanish I wouldn't step foot in there lol Quote Link to comment
mrbigtanker Posted October 26, 2014 Report Share Posted October 26, 2014 Ortley 1 Quote Link to comment
danfiveten Posted October 26, 2014 Report Share Posted October 26, 2014 Dan Hart has her apart, replacing my front end since the wheel fell off due to those faulty washers, hes grinding down some crager washers for me so they will fit and work. Hes also fixing my rear sway bar, replaced my clutch master, adjusting my carbs, and then adjusting my valves. And he did my front brakes. Quote Link to comment
r0p0doe Posted October 26, 2014 Report Share Posted October 26, 2014 Ortley orale* :rofl: Quote Link to comment
datsunfreak Posted October 27, 2014 Report Share Posted October 27, 2014 Drug it from it's weed-infested hole in East Texas where it was slowly dying to our shop so it can hopefully be saved... 1 Quote Link to comment
danfiveten Posted October 29, 2014 Report Share Posted October 29, 2014 Drove her home from dans, need to get alignment done. lug nuts seemed to stay tight, just got this nervous tick with checking every few miles now though.... Quote Link to comment
qwik510 Posted October 29, 2014 Report Share Posted October 29, 2014 Drug it from it's weed-infested hole in East Texas where it was slowly dying to our shop so it can hopefully be saved... Sweet. Looks like you will save another one. Nice job. Is that functional brake ducting in the rear quarter? :w00t: Quote Link to comment
zianian Posted October 29, 2014 Report Share Posted October 29, 2014 I bought it a new house... Quote Link to comment
macgyver Posted October 29, 2014 Report Share Posted October 29, 2014 I bought it a new house... You sell the dime yet? Quote Link to comment
datsunfreak Posted October 29, 2014 Report Share Posted October 29, 2014 Is that functional brake ducting in the rear quarter? :w00t: In fact it is. :thumbup: Don't know if it does much good with drum brakes, but... ^_^ Quote Link to comment
pipelinewill Posted October 30, 2014 Report Share Posted October 30, 2014 drove my ka powered 72 home from washington state today. 5 hour drive, and it's the first drive in 15 months, so it was really exciting. i changed the turbo set up and got a haltech sprint 500 ems as well as lots of fuel system mods and some rust repair, so i was super nervous but it ran good, just needs a tune and some clean up. first time wiring a standalone engine management system and doing this much fabrication an a car, so well see if it all works properly when i get it on a dyno. kinda janky tho so i have my worries. Quote Link to comment
datsunfreak Posted October 30, 2014 Report Share Posted October 30, 2014 drove my ka powered 72 home from washington state today. 5 hour drive, and it's the first drive in 15 months, so it was really exciting. i changed the turbo set up and got a haltech sprint 500 ems as well as lots of fuel system mods and some rust repair, so i was super nervous but it ran good, just needs a tune and some clean up. first time wiring a standalone engine management system and doing this much fabrication an a car, so well see if it all works properly when i get it on a dyno. kinda janky tho so i have my worries. This post needs more photos. B) 1 Quote Link to comment
q-tip Posted October 31, 2014 Report Share Posted October 31, 2014 This post needs more photos. B) Yeah I'm wondering what car this is, I usually keep a pretty close eye on the dimes for sale in the area. Quote Link to comment
Nuclear Water Boy Posted October 31, 2014 Report Share Posted October 31, 2014 Let's see started it up at 0600 backed out of the garage towards the slider door and noticed no brake lights CRAP!!! I rewired my brake light a couple years ago using a relay tossing the POS OEM relay. All other lights work so I'm thinking brake switch or bad connection at the relay. Either way it'll be a multiple beer job, even if it only take 10 minutes Oh Ya!!! Quote Link to comment
edekalil Posted November 2, 2014 Report Share Posted November 2, 2014 Took her to lunch. Quote Link to comment
skyblue Posted November 4, 2014 Report Share Posted November 4, 2014 Gave her a much needed washing. 2 Quote Link to comment
mrbigtanker Posted November 5, 2014 Report Share Posted November 5, 2014 Ready for the drive down south. 1 Quote Link to comment
mytoy521 Posted November 5, 2014 Report Share Posted November 5, 2014 put on my new bluebird mesh jdm grill http://community.ratsun.net/public/style_emoticons/#EMO_DIR#/biggrin.gif http://community.ratsun.net/public/style_emoticons/#EMO_DIR#/twofinger_salute.gifpics? ? Quote Link to comment
shacks510 Posted November 5, 2014 Report Share Posted November 5, 2014 I think it's a little too late to ask for pics. That post was five years ago. 1 Quote Link to comment
shacks510 Posted November 5, 2014 Report Share Posted November 5, 2014 Gave her a much needed washing. Ready for the drive down south. So you'll be at my Ratsun meetup & cruise in? Good! Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.