Rick Rodchester Posted March 14, 2014 Report Share Posted March 14, 2014 What type of fuel is recommended for a '78 620 with a stock carb. I was running rough at idle, I put some sea foam in one tank and in about 20 miles it totally went back to normal. Then 2 tanks of chevron supreme it back...not as bad. but is really making me think it's just the quality of the gas these days. I was considering paying the extra for non-ethenol, but it's a big pain. They will only fill cans where I go. any advise would be helpful thanks. Quote Link to comment
ggzilla Posted March 14, 2014 Report Share Posted March 14, 2014 Use regular pump gasoline. Up to 10% ethanol is OK for a 1980s era Datsun. Now that you've fixed the engine running rough, go back to regular. All gas sold in USA has (by law) cleaners similar to what chevron puts in Quote Link to comment
q-tip Posted March 14, 2014 Report Share Posted March 14, 2014 I've found that the older rigs like premium better but they don't need it. Quote Link to comment
Guest Rick-rat Posted March 14, 2014 Report Share Posted March 14, 2014 I ran some 85 octane gas in mine on my last road trip, ran just fine with it also Quote Link to comment
Rick Rodchester Posted March 14, 2014 Author Report Share Posted March 14, 2014 So then do you have some possible reasons for the not so perfect idle. Other than fuel. Stock carb... Quote Link to comment
Guest Rick-rat Posted March 14, 2014 Report Share Posted March 14, 2014 Maybe a small piece of dirt or something in the carb, do you keep a good fuel filter on it? is it idling to low rpm, mine likes to idle at aboot 850 rpm, lower than that it is not smooth. I threw the stock carb away and put on a weber Quote Link to comment
Rick Rodchester Posted March 14, 2014 Author Report Share Posted March 14, 2014 I have not changed the fuel filter yet. but I should thanks. and the weber is what I was thinking too. I have depleted my resources on this truck to the point where I am truing to wait on that one.. what should that cost me? The report today was that it ran fine, with no rough idle. no tach on it either, so I would have to guess and 800- 900 sounds about like what it doing. might be a little lower, maybe just bump up the idle speed would be a good option. it was her 2nd day driving today, day one ended with a dead batterie.. left the lights on. I am probably just being a little overcautious, I was just curious if anybody has found a benefit to some specific fuel. brand or octane level. I told her to put regular in it next time to see if there was any change. Quote Link to comment
Guest Rick-rat Posted March 14, 2014 Report Share Posted March 14, 2014 I don't put any additive in my gas, just always change fuel filter when they look dirty and keep air filter clean. I think mine was aboot 260.00 new and it is a 32/36 with manual choke. I use gas from what is available when I need gas, no favorites Quote Link to comment
ggzilla Posted March 14, 2014 Report Share Posted March 14, 2014 Same here. Maybe some crud in the fuel that the seafoam carried through. I would 1) drain the tank and pour the gas carefully back discarding the cruddy layer at the bottom of the bucket and 2) change the fuel filter. Quote Link to comment
Dalesun Posted March 17, 2014 Report Share Posted March 17, 2014 I had to change my fuel filter every 2000-3000 miles when I first got my truck. Always fill it up with premium. Ran the non-enthanol 92 octane for awhile but I went back cause I didnt notice a big difference. If anything it was probably placebo haha Quote Link to comment
Cardinal Grammeter Posted March 30, 2014 Report Share Posted March 30, 2014 Don't run the 87 octane low grade junk - it actually has the 10% ethanol in it. Actually, you should NEVER run this fuel because they are cheating you in cost per BTU content, not to mention that any small engine repair guy will emphatically tell you to never use it either. The 89 octane Mid Grade so far has little or no ethanol although EPA, etc. is ramping that up. High Test has no ethanol. My friend buys fleet gas for his taxis and the 87 is called BLEND, 89 is UNLEADED, and 92 is PREMIUM. You can tell the difference in power and fuel economy upgrading from 87 to 89 and that usually only costs 10 cents of about 2.5% more in cost yet you can see over 5% increase in mpg. Quote Link to comment
ggzilla Posted March 30, 2014 Report Share Posted March 30, 2014 Most Premium is 10% ethanol too, depends on where you live I guess. Works fine in my old Datsuns. Yes you'll see an increase in MPG - if you tune the engine for it. Quote Link to comment
datzenmike Posted March 30, 2014 Report Share Posted March 30, 2014 So then do you have some possible reasons for the not so perfect idle. Other than fuel. Stock carb... Small vacuum leak. Loose carb bolts, cracked vacuum hose to brake booster or air snorkel. EGR dirty and not sealing properly (off) at idle Idle mixture not set properly. Valve lash too tight. Timing chain worn causing retarded valve timing Quote Link to comment
tr8er Posted March 30, 2014 Report Share Posted March 30, 2014 I don't think fuel grade is your issue, but I've overwhelmingly found schell to give my wagon the best performance. I thought I was crazy for a while, but enough times with the same result has led me to believe it is not in my head. Chevron has been the worst option. Though most convenient, so I am often reminded that it is terrible. I buy non ethanol often, but not most of the time. Though you should never buy ethanol gas for your chainsaws, weed whackers, or small mowers. Unless you have a crush on your small engine mechanic. Quote Link to comment
smoke Posted March 31, 2014 Report Share Posted March 31, 2014 Leaving the ethanol and other stuff out for a bit, here is a short thing with fuel and octane. You want to run as low of octane as your engine will stand, this is where it will run the best and make the most power, period. I know that's the opposite of most everything you hear, but the fact is, running too high of octane will make you lose power and efficiency of the burn. The higher the octane, the slower the burn rate. This is really most evident in drag racing and guys trying to pull everything they can out of an engine. On a newer race engine, I start off with a really high octane race fuel and start slowly diluting it. It's a really fine balancing act, because if you go too far (too low of octane) you're going to get detonation. But. until that point, you will get faster, because the fuel burn is getting closer to matching your compression ratio (so to speak). On a street driven, engine, do a similar thing, if it pings on regular, up it to plus. If it does not ping on regular, you're about as good as you're going to get. Quote Link to comment
MikeRL411 Posted March 31, 2014 Report Share Posted March 31, 2014 Regular, Premium and Mid Grade all have the same Ethanol content. There are only 2 gasoline "grade" storage tanks at the station. Mid Grade just mixes the Regular and Premium 50%/50% at the pump. Watch the little meters on the face of the pump at your next fill up. Quote Link to comment
DanielC Posted March 31, 2014 Report Share Posted March 31, 2014 I live in Oregon, and we have had E-10, for a long time. This is may experience with it. My Datsun runs fine on it. I have been running Ratsun since August, no fuel issues. When I was doing work on Ratsun, I did get the gas tank cleaned out, at a radiator shop. I run E-10 in my Ski Nautique. I have since it was new, in November of 1996. My boat has 2,509 hours on it. A boat does have a large water separating fuel filter, with a drain on it. Running E-10, I have found NO water in the gas. If you have NOT been running E-10, switching to it can cause problems. The alcohol will dissolve water in the tank. if there is a very little amount of water, the alcohol dissolves the water, and the alcohol remains dissolved in the gas. All three liquids got through the carb, and engine, and two are burnt. No problem. If there is a large amount of water in the tank, the water and alcohol separate from the gasoline, go to the bottom of the tank, and the fuel pump sucks up water with dissolved alcohol, and this creates problems, water does not burn. Another issue with switching to E-10 is the alcohol will dissolve some gunk in the gas tank, and run that gunk into the fuel pump, and engine. This can create some problems, most commonly a clogged fuel filter. With a carburetor, switching to E-10 will make the engine run slightly leaner. You can also expect a slight fuel mileage drop, because alcohol has less energy content per gallon, than gasoline. Quote Link to comment
ggzilla Posted March 31, 2014 Report Share Posted March 31, 2014 Yes, in Washington we've had E10 since about 1989. I remember those 10% stickers on the pump. Datsun used good fuel lines so no problems. Quote Link to comment
Cardinal Grammeter Posted April 21, 2014 Report Share Posted April 21, 2014 It does vary by state and I'm in PA. And there is a move, worldwide, to use more and more ethanol. So time is running out. You can measure the amount of ethanol in your gas by doing a test where you fill a test tube, cylinder, graduate, etc. about 1/4 water and 3/4 gasoline and then shake it up. The water will absorb the ethanol and after it settles, the water level will be higher. Since ethanol content is something that is basically kept secret, that is probably the only way to be sure. I know here in PA, its only in the low test - of course that was 1-2 years ago when I was researching this. That doesn't mean things haven't changed. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.