Jump to content

POST Craigslist ads here...


Recommended Posts

ok anyone who knows Datsun Bill of Elma, Wa knows the Dragon Wagon.. well it's for sale! Uncle Bill is selling his goonie..

 

 

 

 

Datsun Bills Dragon Wagon

 

 

 

 

FOR SALE: 1968 DATSUN 510 WAGON

 

LZ-22 LONG ROD ENGINE.

 

280Z- 5 SPEED TRANSMISSION.

 

HAS DUAL SIDEDRAFT 45mm DELLORTOS CARBS.

 

BRE INTAKE, A-87 HEAD (D-PORTED)

 

HOOKER SUPER COMP. HEADER. (1 5/8" PRIMARYS)

 

1.73 INTAKE VALVES. 280 DURA. CAM.

 

U-20 2000 ROADSTER VALVE SPRINGS.

 

PISTONS ARE VG30 FLAT TOPS .030 OVER.

 

Z-22 BLOCK M-1 (HAS HEAVIER MAIN WEBBING)

 

HIGH COMPRESSION HEAD. RODS ARE- 5.85". 17 lb. FLYWHEEL.

 

U-20 PRESSURE PLATE & CLUTCH. FULL ROTATING ASSEMBLY (BEEN BALANCED)

 

HAS A 1982 - 200SX - 190mm REAR END. (3:90 RATIO) (29 SPLINE)

 

MILLER LOCKER (FULL POSI)

 

REAR DISC BRAKES

 

15" MODERN 5 STAR WHEELS. (GOOD TIRES)

 

PILOT STEERING WHEEL.

 

ENGINE RUNS "VERY" STRONG.

 

LESS THAN A "1000" MILES ON ENGINE.

 

LICENSED UNTIL 9/12.

 

HAS SOME SOME DIMPLE DINTS IN BODY. VERY LITTLE RUST.

 

GOOD DASH (NO CRACKS)

 

 

IF INTERESTED CALL: BILL SR. @ 360-482-6312

 

 

PRICE: $5500.

 

 

 

 

 

 

 

pictures in the ad.. VERY clean VERY powerful.. well worth the asking price

 

 

Link to comment
  • Replies 6.1k
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

smoking fucking deal right here

 

datsun 620 suspension - $200 (vancouver)

 

http://portland.craigslist.org/clk/pts/2835886803.html

 

Selling complete suspension for a 78-79 datsun 620. parts are all cleaned and painted with new ball joints an bushings. Rotors are turned with new packed bearings loaded in. Also have new pads and brake hoses. I was going to use these on my 77 620 before I found out it wont fit . I am asking $200 just to get back my cost in parts. Call Stan @ 360-two1three-5793. Leave a message, I'll call back;

 

5N85Kc5H83F33L13Mcc25e94776a27a1d16cf.jpg

 

5G25Kf5Fd3Gd3I83J5c2505b308d2a01116a5.jpg

Link to comment

ok anyone who knows Datsun Bill of Elma, Wa knows the Dragon Wagon.. well it's for sale! Uncle Bill is selling his goonie..

 

Datsun Bills Dragon Wagon

 

 

FOR SALE: 1968 DATSUN 510

IF INTERESTED CALL: BILL SR. @ 360-482-6312

 

 

pictures in the ad.. VERY clean VERY powerful.. well worth the asking price

 

 

Bump!!! I have seen this car in person and was left drooling it's a great looking ride and it's deffinately fast and ha a lot of good work put into it. Bill knows his stuff and I am positive everything was done right.

Link to comment
Guest kamakazi620

Been posted. Been reposted. Then again. That cat just can't sell it.

It's a POS the PO welded RX7 coilsprings on the back and 1 broke it used to be baby blue OG paint crappy rattle can paint now Stay away unless $400

Link to comment

Yea, I seen it also, your not going to find them like this very often, if I didn't already have one I would go look at this for sure.

It looks like it has the 65 stick shift tunnel, but the 64 grill, I thought that the 65 tranny went with the 65 grill.

I don't have any room, someone buy this!

http://portland.craigslist.org/clc/cto/2839357717.html

5Na5La5M13k43M53N4c27fe4fda0c0511108f.jpg5Nc5Hc5M13Gf3F53H4c27648b199a49ff1cee.jpg

 

5N15Z15H43nd3N63H4c273aea8bec26c31558.jpg5Na5Ib5W13G73L93Hfc27fcd19d4c1f1f13a5.jpg

Looks like the door has a dent, and it needs seats and a gas tank.

Link to comment
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.