skyblue Posted August 15, 2013 Report Share Posted August 15, 2013 What about on the fender well. Where the battery used to be. Quote Link to comment
Busta Nut Posted August 15, 2013 Report Share Posted August 15, 2013 Right on dude!! This is bad ass!! I would go with a fender mount or on/near the rail..... I would't want to see the gauge as I open the hood..... Quote Link to comment
mrbigtanker Posted August 16, 2013 Author Report Share Posted August 16, 2013 So good ideas,one i put the gauge at the end of the fuel rail.It does not look to bad and now it will free up room to put it on the fire wall next to the ITB's.Also as for the fender well i got this cool oil filter relocation system so it will go on that side of the fender well,i dont want it to look to cluttered but it is a small engine compartment so trying to go clean some what with some cool parts shown also.will post some pics later. Quote Link to comment
Steve521 Posted August 16, 2013 Report Share Posted August 16, 2013 Lookin' good! Following this thread with great anticipation. ;-) Quote Link to comment
4perrev Posted August 17, 2013 Report Share Posted August 17, 2013 Dude, When are you going to put something shinny on that truck???!!! :rofl: It's looking bad ass! Quote Link to comment
datson4life Posted August 17, 2013 Report Share Posted August 17, 2013 what about the ka red 521, what happened to that one? Quote Link to comment
mrbigtanker Posted August 17, 2013 Author Report Share Posted August 17, 2013 Dude, When are you going to put something shinny on that truck???!!! :rofl: It's looking bad ass! I need money to do that. :rofl: Quote Link to comment
mrbigtanker Posted August 17, 2013 Author Report Share Posted August 17, 2013 what about the ka red 521, what happened to that one? Still have it the timing chain tensoner took a sheet so i have that at the shop,i am focusing my time on the green one.Now i am going to cut the bottom of the bed off or the skirts i had made and make new ones that will look way better and i am going to 4 link the rear when time allows.Right now just trying to get it started for JCCS. Quote Link to comment
mrbigtanker Posted August 17, 2013 Author Report Share Posted August 17, 2013 1 Quote Link to comment
mrbigtanker Posted August 17, 2013 Author Report Share Posted August 17, 2013 So much cleaner under the truck. Quote Link to comment
thisismatt Posted August 17, 2013 Report Share Posted August 17, 2013 Lookin good. That center link looks a lot better now. Quote Link to comment
Jdm720 Posted August 17, 2013 Report Share Posted August 17, 2013 Your truck needs flaps. Quote Link to comment
datson4life Posted August 18, 2013 Report Share Posted August 18, 2013 what kinda starter is that? im done with autosone ones wait nevermind thats not for l series Quote Link to comment
Phixius Posted August 18, 2013 Report Share Posted August 18, 2013 lookin good Nui! starter looks like a gear reduction starter? Quote Link to comment
mrbigtanker Posted August 18, 2013 Author Report Share Posted August 18, 2013 Actually it is a L series starter they fit the FJ20'its my polished one from the other guy i bought it from but i had it all gone through again and i just powder coated the mag,no polish this time just the clean sano some what look. Quote Link to comment
4perrev Posted August 18, 2013 Report Share Posted August 18, 2013 I need money to do that. :rofl: I know you got money after looking at that engine or are you broke now?? Quote Link to comment
mrbigtanker Posted August 18, 2013 Author Report Share Posted August 18, 2013 Sure I dont have money. :devil: Quote Link to comment
mrbigtanker Posted August 21, 2013 Author Report Share Posted August 21, 2013 Getting the radiator redone i figured why buy a new one when this one will work just fine,getting the fuel system done a few more odds and ends and next is wire the EMS 4 and sensors and crap up. I am going to redo my front bumper and get the bed skirts done again and some other subtle things done,i also want to do a new dash board so working on new ideas.I am going more then likely speed hut but i am also looking up the racepak,its single cable to EMS and i can do a GPS speedo. Quote Link to comment
mrbigtanker Posted August 21, 2013 Author Report Share Posted August 21, 2013 So this is were i am at now,i think it looks cleaner with the coils in the there.Plug wires go back in the box for dust collection.lol Also got the fuel reg mounted up or mocked up can been seen yet still hidden.Few more things to do. 1 Quote Link to comment
mrbigtanker Posted August 21, 2013 Author Report Share Posted August 21, 2013 Still got this junk to put in.Radiator should be done by friday,and i found this really cool hose clamps i will post pics when that time comes to see if they will work. Quote Link to comment
mrbigtanker Posted August 21, 2013 Author Report Share Posted August 21, 2013 On a side note looked at some other small trucks i mean big trucks,thinking about getting back in to it tanker hauling,nothing black though,but this some what candy blue one caught my eye. Quote Link to comment
mattyhacks71 Posted August 21, 2013 Report Share Posted August 21, 2013 What you need is something that's older and has more character but get the interior done up in a modern way B) 1 Quote Link to comment
4perrev Posted August 22, 2013 Report Share Posted August 22, 2013 Dude, I'm with Matty here. You need some old as semi and then doll it up like the Datsun!! Quote Link to comment
mrbigtanker Posted August 22, 2013 Author Report Share Posted August 22, 2013 I have done 1 already well it was a 1997 Pete long hood Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.