PineClone Posted June 19, 2023 Report Share Posted June 19, 2023 Hi all! Been a while since posting here, but finally have an issue i'm getting around to trying to solve. My '78 B210 has a weber carb, and the previous owner removed all of the emissions components when he installed it. When i park it in the garage after driving it, the garage becomes permeated with the smell of fuel. I know that these old cars are known for the exhaust smell, and my 240Z had the same thing, which i actually kind of liked. But this is to another level. I have no idea if there is a way to easily add the carbon canister back into the workings. Or maybe there is some other solution?? My car runs like a dream, so I'm not too interested in making any major changes. Thanks in advance! -Scott (Wenatchee WA) Quote Link to comment
banzai510(hainz) Posted June 19, 2023 Report Share Posted June 19, 2023 (edited) I run Weber DGV and dont really have that smell. Is the accel pump diaphrame on the side of the carb ok? Meaning its not leaking from the side? cycle the linakge and watch (not running and see if gas comes out from somewhere. float level OK maybe its too high? have pvc valve? Edited June 19, 2023 by banzai510(hainz) Quote Link to comment
PineClone Posted June 19, 2023 Author Report Share Posted June 19, 2023 Will do! Thanks! Quote Link to comment
datzenmike Posted June 20, 2023 Report Share Posted June 20, 2023 Visually check all exposed fuel delivery hoses and lines for obvious dampness. Specially the filler hose and tank vent line into the engine compartment. The tank vent normally goes to the canister that saves any fumes evaporated from the tank. If it's still open you can't just seal it up because the gas cap isn't vented, it's a sealed system. Best to get another canister and connect it properly. The purge line is usually connected to the vacuum advance on the distributor. Tank vent to the nipple marker tank. The last line is a connection to the intake. The purge signal opens the valve and allows the intake vacuum to draw in the stored fumes. Pretty simple. Vacuum advance likely has a TVV that prevents vacuum advance until engine is warmed up. As all engines are about the same, gas tanks and intake vacuum, just about any canister from a wrecking yard with three connections should work. That said I don't think evaporated gas from the tank vent is of such volume that it stinks up the garage. Some later '80 carburetors have a vent line from the carburetor float chamber to the canister. After shut down the engine heat will cook the gas in the carburetor and give off fumes. This is the most likely source of fumes other than a leak in the fuel lines or tank. 1 Quote Link to comment
Stoffregen Motorsports Posted June 20, 2023 Report Share Posted June 20, 2023 I'm having a similar issue with my classic Jeep Cherokee. And I am trying to reinvent the wheel by re-engineering the charcoal canister/fuel tank venting systems. But on a Datsun, even without any vapor tank, I've never experienced the fuel smell enough to care. Quote Link to comment
datzenmike Posted June 20, 2023 Report Share Posted June 20, 2023 No doubt on a warm day there will be some out gassing but minimal. It's likely the Weber, float set to high, or flooding, may be leaking. 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.