Tuan Posted September 25, 2011 Report Share Posted September 25, 2011 SUP YALL!!!!! Been working on this for the last couple of days. I got my Z running really good, installed a new carb cam on my Holley and adjusted the float level which was way low. Runs great, brakes are still wack but now Z strut bar is done. This SHIZZLE is like OEMizzle. Datsunfizzle! 2"x36" HOMEDEPOT C channel $14 dorras + (2) 3/16" custom cut end plates: $26 bucks = $40 Time: 1 hour. DUCER STRUT BAR > MSA <-----wIMPY WIMPY ^HEFTY HEFTY Quote Link to comment
josh_t Posted September 25, 2011 Report Share Posted September 25, 2011 that actually looks pretty sexy. Quote Link to comment
Daz Posted September 25, 2011 Report Share Posted September 25, 2011 I dig it ! Now make me one ! Quote Link to comment
datzenmike Posted September 25, 2011 Report Share Posted September 25, 2011 That you skib??? Quote Link to comment
flatcat19 Posted September 25, 2011 Report Share Posted September 25, 2011 That you skib??? Obvious troll not so obvious. Quote Link to comment
Tuan Posted September 25, 2011 Author Report Share Posted September 25, 2011 That you skib??? SKIB: Skilled- Knowledgeable Inventive badass. YES I AM! Get your post off my thread you dirty stinking APE! Hahaha. DR. ZAIUS, DR. ZAIUS, DOOO DOOO DOOOO DOOO, GETTING READY FOR EAGLE ROCK SWAP MEEEEEEEEEEEEEEEEEEEEEEEEEET, WOOOOOOOOOOT! Quote Link to comment
Dee Posted October 18, 2011 Report Share Posted October 18, 2011 that is slick, wanna make me a set? :P Quote Link to comment
Tuan Posted October 19, 2011 Author Report Share Posted October 19, 2011 that is slick, wanna make me a set? :P Hahaha. Let me make the front bar and then we can talk., Wink Wink. I only made the rear now. The front is also not difficult but I've ran into major issues and dealing with them right now, so soon, my friend. =) I stopped fabricating since the ignition switch went out, and I finally figured out an Electrical demon that just occured, which was a super combination that took me 2 days to figure out. 1. LED bulbs were bad and the turn signal didn't function properly, 2. The main harness plug, one of the pin for some god damn reason was the signal pin, didn't contact. Leaving me puzzled at this Coo Coo Combo Breaker. Ultra Ultra!!!!!!!!!!!!!!! failed electrical headache. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.