jesusno2 Posted April 24, 2010 Report Share Posted April 24, 2010 i have a ka24e powered 510 wagon this thing runs like total shit! i have no idea whats going on ive tried it all! No codes (exept the 55 code), new sensors, ohm tested everything even checked voltage going and coming from the ecu etc. iac cleaned, cant find any vaccumm leaks everything works like it should. the car runs so rich, and it wont idle at all. timing is set 15 degrees, tps is set, iac valve basically does jack shit, im at a total loss ive been trying to figure this out for about a year now. i just keep movin on to other projects. the motor is basically new great compression etc. I need physical help or good advise before i lose my god damn mind! anyone live near salem? i just put a fuel pressure reg on it and set it to the factory service manual specs 43lbs with no vaccumm 33 with vacumm did absolutley nothing still rich as hell and wont idle. Quote Link to comment
metalmonkey47 Posted April 24, 2010 Report Share Posted April 24, 2010 Did this all start after you swapped in the motor? Quote Link to comment
jesusno2 Posted April 24, 2010 Author Report Share Posted April 24, 2010 not quite sure what ya mean by that? its never has idled very well. now its gotten to the point where i havent changed a thing and now it just magically started to run like POOP! Quote Link to comment
metalmonkey47 Posted April 25, 2010 Report Share Posted April 25, 2010 So what your saying is that it's always had an idle problem prior to this point? And then one day it just randomly goes down the toilet, correct?? Quote Link to comment
HRH Posted April 25, 2010 Report Share Posted April 25, 2010 Have you replaced your primary 02 sensor? And have you verified your mass air flow sensor is not fluffed? Quote Link to comment
jesusno2 Posted April 25, 2010 Author Report Share Posted April 25, 2010 Its something not related to anything the ecu controls or needs cause it has no fault codes. So its either fuel related which it is running very rich or eletrical which I'm going back through cause I don't think my alternator is workin. Quote Link to comment
metalmonkey47 Posted April 25, 2010 Report Share Posted April 25, 2010 I'd say the first place to go is O2 sensor, but if it's not throwing any codes that wouldn't necessarily be it right? Are you sure you don't have a problem with the ECU? My mom's minivan had a short in the ECU that was causing all kinds of problems with the camshaft position sensor and throwing no codes. We went all over the place trying to get it fixed and ended up having a re-mapped ecu installed. Quote Link to comment
jesusno2 Posted April 25, 2010 Author Report Share Posted April 25, 2010 its possible i have tried multiple ecu's with no results everything seems fine except cold start and idle it revs fine its almost like it never comes outta the enrichment cycle for a cold start and just dies it always restarts just wont idle it shuts off almost as if ya just turned the key off its really hard to explain online. Quote Link to comment
metalmonkey47 Posted April 26, 2010 Report Share Posted April 26, 2010 So it's running cold that it causes problems and when the engine warms up the problems either cease or become less consistent? I'm just trying to make sure I understand 100% here. Can you make a video of it? Quote Link to comment
jesusno2 Posted April 26, 2010 Author Report Share Posted April 26, 2010 ok so i'll describe it in short. start car runs on high idle like it should. about 5 seconds later it trys to idle down and dies, it will idle very very rough when warmed up,eventually stalling. and thats it no codes nothing outta place thats why im asking for some help. my last guess is something voltage going on somewhere, my alternator is really confusing me cause when i un hook the 2 wire plug from it and the positive cable from the battery my car stays running?????????????? wtf when i leave the plug for the alternator pluged into the alternator my battery will go dead overnight. Quote Link to comment
nismo dr Posted April 26, 2010 Report Share Posted April 26, 2010 Its something not related to anything the ecu controls or needs cause it has no fault codes. So its either fuel related which it is running very rich or eletrical which I'm going back through cause I don't think my alternator is workin. When Nissan air flow meters fail, they very rarely set codes. They just go all haywire trying to compensate for whatever it thinks its seeing. I wouldn't assume its good because of no codes. Quote Link to comment
datzenmike Posted April 26, 2010 Report Share Posted April 26, 2010 ok so i'll describe it in short. start car runs on high idle like it should. about 5 seconds later it trys to idle down and dies, it will idle very very rough when warmed up,eventually stalling. and thats it no codes nothing outta place thats why im asking for some help. my last guess is something voltage going on somewhere, my alternator is really confusing me cause when i un hook the 2 wire plug from it and the positive cable from the battery my car stays running?????????????? wtf when i leave the plug for the alternator pluged into the alternator my battery will go dead overnight. Are you using the KA alternator or stock 510 with external regulator? Usually a bad diode will discharge it overnight. Quote Link to comment
Datsun fan Posted April 26, 2010 Report Share Posted April 26, 2010 Maybe a leaking or fucked up fuel injectors ? Running crappy rich means: 1) bad injector 2) Bad sensor 3) No spark at the plugs 4) faulty ECU Quote Link to comment
jesusno2 Posted April 26, 2010 Author Report Share Posted April 26, 2010 Well normally when maf sensors go bad and the ecu goes into limp mode correct? I assume mine is working cause when I unhook it the engine dies instantly I'm running the stock ka24e alternator I did the jumper wire trick with the wiring to bypass the external reg. I hooked the big fat white wire directly to power and the little yellow wire to what I assume is the charge light in the dash. I don't know how to test for leaky injectors I put new orings on them and I tested another set I have but nothing changed so I kinda ruled that out Quote Link to comment
jesusno2 Posted May 9, 2010 Author Report Share Posted May 9, 2010 bump with video!!!!!!!!!!!! http://www.youtube.com/watch?v=4aymQLhoI2Y Quote Link to comment
metalmonkey47 Posted May 10, 2010 Report Share Posted May 10, 2010 It's strange, it seems to be running quite well above idle. I almost want to say that it's getting too much gas at idle. Perhaps a fault in the ECU? Have you considered running by Nissan and having them run diagnostics on the ECU? Usually it's done no charge. My mom's minivan had a problem where the ECU was saying the camshaft position sensor was bad, but everytime you replace it it would still run like shit with a check engine light. If you unplugged the sensor it would go into limp mode and revert to factory specs and it would run fine with no light. Took it to many mechanics, and none found the fault. Took it by Chevy and they tested the ECU and found a fault causing a short in the circuit for the CPS. You could be having a similar problem. Quote Link to comment
jesusno2 Posted May 10, 2010 Author Report Share Posted May 10, 2010 If thats the case then i would have 3 ecu's with all the same fault. cause ive tried 3 different ones! im starting to think i have something really funky going on with the idle air control i dunno what though. I've cleaned it, inspected it etc the solinoids are clicking but i noticed with it running it makes this hissing sound through the intake when i unplug it it quits but it still wont idle. Quote Link to comment
MicroMachinery Posted May 10, 2010 Report Share Posted May 10, 2010 Did you ever get that IAC in the mail? Wasn't that what you were waiting for? Or was it a fuel pressure regulator.. I forget.. Quote Link to comment
jesusno2 Posted May 10, 2010 Author Report Share Posted May 10, 2010 Yea I got it it was just a adapter that bolts onto the stock fuel rail that takes place of the stock fpr Quote Link to comment
yello620 Posted May 10, 2010 Report Share Posted May 10, 2010 Have you tried a different IAC yet? or just cleaned the one you have? Quote Link to comment
fastdadd Posted May 10, 2010 Report Share Posted May 10, 2010 bad vacuum leak maybe Quote Link to comment
jesusno2 Posted May 10, 2010 Author Report Share Posted May 10, 2010 Yes I have doubles of every sensor on this motor I've put on my other iacv on with no change if I do have a vaccumm leak ts internal somewhere cause I've checked everywhere else. I only have one hose and the actuall Intake itself. Quote Link to comment
jesusno2 Posted May 11, 2010 Author Report Share Posted May 11, 2010 so i just blew 2 full cans of carb cleaner trying to find a vaccumm leak couldnt find shit!!! anyone got a ka24e mikuni intake im done with this worthless fuel injection garbage. Quote Link to comment
metalmonkey47 Posted May 11, 2010 Report Share Posted May 11, 2010 Maybe your Datsun is begging for a another I6. lol I'll speak to a mechanic friend of mine tomorrow if I get the chance. He took courses in Nissan's at UTI in Florida.. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.