datsun 510owner Posted October 29, 2020 Report Share Posted October 29, 2020 does any one knows if the 1982 datsun pick up transmission fit on a 1972 pick up with a L1600 motor ? Quote Link to comment
Draker Posted October 29, 2020 Report Share Posted October 29, 2020 It will bolt up but it will be tilted to the side about 15 degrees or so. Not ideal. This can be fixed by swapping the bell housing, but might as well fine a different tranny if you are hunting. An 80 720 transmission will work since they had an L20b. Later years use a z series engine which rotate the bolt pattern. Quote Link to comment
datzenmike Posted October 29, 2020 Report Share Posted October 29, 2020 The later 720 had a short 5 speed same length as the 521 so that would save you shortening the drive shaft, but you would still need a 4 or 5 speed front case to convert it so it would fit properly. 1 Quote Link to comment
yenpit Posted October 30, 2020 Report Share Posted October 30, 2020 23 hours ago, datsun 510owner said: does any one knows if the 1982 datsun pick up transmission fit on a 1972 pick up with a L1600 motor ? If you already have this later NAPZ 5spd, find a 71-78 (not the early 70-71) 240 260 280Z 4spd, pull the front case half (bellhousing ) & bolt on swap to the NAPZ 5spd. This bellhousing will correct the clocking, thus alleviates the bad tilt! I have sold 10++ of these 4spd bellhousings for this swap. Expect to pay $100-150 + shipping for the 4spd bellhousing. I do not have any at this moment, but I do have a 280Z parts car with the 4spd in it, but we are going racing at COTA in TX, back after Nov 11th. FYI if you were looking to install the even later 240SX 5spd, that trans has a larger front bearing, which requires machining out the bellhousing to fit the 240SX trans. 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.