Eagle_Adam Posted April 22, 2013 Report Share Posted April 22, 2013 long story short: found a "missing" bolt during the tear down turns out it wasnt missing... and broke an easy out in it.. So , now im looking for options, if you have an L20 with a good bottom end im interested Link to comment
tdaaj Posted April 23, 2013 Report Share Posted April 23, 2013 I've got a couple clean blocks, one z20 and one L20 Link to comment
hang_510 Posted April 23, 2013 Report Share Posted April 23, 2013 long story short: and broke an easy out in it.. yep. :pirate: wouldn't be surprised it if was the same bolt for me. if you want to do an LZ, i have a Z24 bottom end and covers and chains avail Link to comment
Eomund Posted April 23, 2013 Report Share Posted April 23, 2013 How about drilling it out and re-tapping it? 1 Link to comment
Eagle_Adam Posted April 23, 2013 Author Report Share Posted April 23, 2013 I've got a couple clean blocks, one z20 and one L20 Clean blocks as in good rings or clean blocks as is good cores to rebuild? yep. :pirate: wouldn't be surprised it if was the same bolt for me. if you want to do an LZ, i have a Z24 bottom end and covers and chains avail It was a timing cover/water pump bolt on the pass side...... How about drilling it out and re-tapping it? i got it sorted last night!!! http://community.ratsun.net/topic/52622-round-2-fight-finally-found-the-right-one/page-18 1 Link to comment
Eagle_Adam Posted April 23, 2013 Author Report Share Posted April 23, 2013 BUT! Im still looking for an L20 bottom end/motor that i can regasket and not have to mess with the bottom end internals. Link to comment
tdaaj Posted April 27, 2013 Report Share Posted April 27, 2013 Good clean blocks with no internals. Link to comment
jvb5577 Posted April 27, 2013 Report Share Posted April 27, 2013 I have a block (U95 M2) but not sure how shipping will work. Link to comment
blueghost510 Posted May 2, 2013 Report Share Posted May 2, 2013 Put a nut over it, weld a bead or two on the inside remove the bolt. Link to comment
Eagle_Adam Posted May 2, 2013 Author Report Share Posted May 2, 2013 Put a nut over it, weld a bead or two on the inside remove the bolt. I got it sorted last night!!! http://community.ratsun.net/topic/52622-round-2-fight-finally-found-the-right-one/page-18 ;) Link to comment
AWSpoofwil Posted May 5, 2013 Report Share Posted May 5, 2013 i still got my block adam, FB message me or text me about it. ill sell it cheap just to get rid of it lol Link to comment
Eagle_Adam Posted May 5, 2013 Author Report Share Posted May 5, 2013 Didn't one of the cylinders have low compression? Link to comment
Recommended Posts