jrock4224 Posted March 18, 2014 Report Share Posted March 18, 2014 so is this the correct input shaft for a 620 5sp... we measured for a 521 and then tried to intall and its about a inch too long... Quote Link to comment
bananahamuck Posted March 18, 2014 Report Share Posted March 18, 2014 so is this the correct input shaft for a 620 5sp... No it isn't As that is an output yoke 1 Quote Link to comment
datzenmike Posted March 18, 2014 Report Share Posted March 18, 2014 That D/S is from a 5 speed 620??? If the spline is bottoming out trim it off. If the U joint is too close it will need to be shortened. Polish that rust off or it will eat the rear seal. Quote Link to comment
jrock4224 Posted March 18, 2014 Author Report Share Posted March 18, 2014 thinking its too long ... yeah u know what my dislexic ass meant ... i don't know what u mean about the u joint being to close ... thinking the polished part is too long and and bottoming out in the tranny Quote Link to comment
bananahamuck Posted March 18, 2014 Report Share Posted March 18, 2014 Went out and measured a couple different ones just now and both measured 2 1/2 inches from the end of shield thing to the very end of shaft. Quote Link to comment
datzenmike Posted March 18, 2014 Report Share Posted March 18, 2014 Here's two. The top one is from a 720 4x4 and it's shorter with no problem. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.