viper graphix Posted July 20, 2009 Report Share Posted July 20, 2009 Can any one help with oil spray bar mods to install in L18 for my 510?????I have looked* and do to not knowing how to navegate the many sites I come up lost.:confused:Much appreciated.THANKS Quote Link to comment
Guest DatsuNoob Posted July 21, 2009 Report Share Posted July 21, 2009 (edited) I think there was a picture and maybe even a couple paragraphs on it in the Honowentz book, HOW TO MODIFY YOUR L SERIES? Didn't look too hard to do. You have to drill into your valve cover, and run a line off your oil pump I think, but not 100%, I hear it's beneficial to upgrade to the KA oil pump for that kind of set-up, this may help a little http://datsun510.wikia.com/wiki/Nissan_L_engine_cylinder_heads good luck on the search Edited July 21, 2009 by DatsuNoob Quote Link to comment
69FJWagon Posted July 21, 2009 Report Share Posted July 21, 2009 I have seen them installed and they dont look to hard to do just some good measuring before the drilling, run a tee off of the oil pressure tap on the side of the block to the fitting on the valve cover... With that said totally not needed if your running a cam under a 1/2" lift with stock valve springs Quote Link to comment
banzai510(hainz) Posted July 21, 2009 Report Share Posted July 21, 2009 clayton You know your not going to run a half inch cam with STOCK valve springs! just get a 280zx turbo oil pump or a KA pump Quote Link to comment
viper graphix Posted July 21, 2009 Author Report Share Posted July 21, 2009 Thanks for help I'll check into it . Time is tight don't know whem it will happen. Just getting info at this time. Car runs fantastic but I like long shifts and don't know how that will effect or create oiling issues. Thanks Quote Link to comment
69FJWagon Posted July 21, 2009 Report Share Posted July 21, 2009 claytonYou know your not going to run a half inch cam with STOCK valve springs! just get a 280zx turbo oil pump or a KA pump :lol::lol::lol: I know, but some have tried Clayton Quote Link to comment
hang_510 Posted July 21, 2009 Report Share Posted July 21, 2009 i dont have a way to upload the directions... try contacting wolf creek racing and see if they have them, they sell them. i can post the dimensions and pix of my install... 3(2-s / 1L) holes in the VC, & a wee bit of grinding on the support ribs. Quote Link to comment
bonvo Posted July 24, 2009 Report Share Posted July 24, 2009 pl521sss modified a z car one ill see if i can track down a link Quote Link to comment
hang_510 Posted July 24, 2009 Report Share Posted July 24, 2009 try contacting ... design products :o Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.