novita1021

Right now a have a 620 with no engine in it so it's the perfect time. I was gonna put a l20 in it in about a week. But I might be able to wait. Also have to swap my 280zx 5 speed over into a sr20 bellhouseing for testing

Would these work on 620 trucks too?

So what's the status on the sr mounts??

I would like a 7k rpm motor. My friend says it's possible with the right cam and carb set up. It's gonna be in a 620. I want the low end torque but when I'm over the 5k rpm mark I want that power I might even shoot a small shot of nitrous. Carb for now would be a 38/38 weber till I get my mikuni 44s rebuilt.

Good info Mike I'll be trying that out tomorrow when I get a chance. I'll update when i get it done.

Hello everyone. I'm building a lz24 for my 620 king cab. as of right now i have everything but I'm trying to figure out what head I want to put in. I currently have a u60 head i got from a friend. Head has work done to it I just don't know what. it has shims under the cam towers, a port job on the intake, Crane Cams cam # DA-272-2-10 NC and it also has 162-17-9. I also noticed that the head lash pad retainers are taller on the intake valve and shorter or sunken in on the exhaust side. Its open chamber but also looks like its been milled down quite a bit. i wanna run the head but my friend says that i might bend the valves. Z24 bottom end has dished pistons. Any help or info would be greatly appreciated thanks guys.

Spotted a maroon 2dr with flares and what looked to be 17s gold with polished lip headed north on the 405 just past Hawthorne. looked real clean.coulnt get a pic though. Then an hour later on the 405 south I saw this one Gave a thumb up and took my exit lol Lake Forrest Dr.

Pm'd ya sir need your help

If you do sell them let me know I'll pick them up where you located?

Bababooey what are you running in the rear?

Hmu I'm in los Angeles maybe u can help 323-404-7375

I might have the eye brow trim and head light cover I call my cell is 323-494-7375

I would love this but now money.