Wanted Datsun 1200 parts

Do you have a Sedan or Coupe?  The windshields are different sizes.

Do you want Intake oval port manifold and carbs, that are stock SU's Hayashi  or aftermarket side draft manifold and carbs?

glhs399 8

Posted March 29, 2022

Windshieldstogo.com list windshields for 1200 coupe, may be best to call them and check availability.

scottsoldautorubber.com.au has front windshield gaskets, both with/without groove for chrome trim.

There more expensive then most but I have had one in my coupe since 2010, still supple.

I run a H89 with dual springs on my A12, but I run 42mm SU's that Steve from Z Therapy built for me, they work very well on my engine built to withstand 8,000 rpm.

I have A14 blocks, crankshafts, long blocks etc, also have an A15 crankshaft, they fit in a A14 blocks without any troubles.

You know if you are going to run 40mm or 44/45mm carbs?  I have side draft intake manifolds for the 44/45's for sure.

Have you considered which exhaust header you wish to use?

If you go to A14/15, the increase in torque will break the 56A trans and the H145 rear end, so what trans/rear end were you thinking of using??

I ask because the later is what has kept me from going to a larger engine producing more torque.