seannn Posted April 26 Report Share Posted April 26 Hello I realize that when I put it on 4wd it doesn't turn the green light on the dash. Where on the transfer case the pug for that is located? Quote Link to comment
Thomas Perkins Posted April 26 Report Share Posted April 26 (edited) Here is the 4WD switch.On page TF-3 in the 85 Nissan Service manual.I just got my flash light and found it.Get a 19 mm or a 3/4 inch open wrench end and take it off.I just put the wrenches on it.To get to it.Where the drive shaft from the front comes into the transfer case.The is a opening there to get your wrench on it.Also it is below the emergency brake cable adjuster.Easy to get to.Use a flash light.May have to go thru the side to get the 2 wires off of it. Edited April 26 by Thomas Perkins 1 1 Quote Link to comment
seannn Posted April 26 Author Report Share Posted April 26 Thank you very much! 1 Quote Link to comment
datzenmike Posted April 26 Report Share Posted April 26 Unplug the switch and get a $5 test lamp and check the Red/Blue wire for 12v. Place in 4WD and check the Black wire for 12v. If you get 12v then the switch is working and the Black ground wire isn't grounded. If everything checks out there is a remote chance the bulb may be burned out 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.