ohmrchristopher Posted May 27, 2012 Report Share Posted May 27, 2012 My rear u-joint let go, need a d-shaft or the flange but ppl said the shaft would be easiest? Straight nice and all that goodness shipped to 98230 WA PLEASE!! The sooner the better because I need to move my truck. :D Pictures for phun. broke mang by NickedKnuckles, on Flickr broke mang by NickedKnuckles, on Flickr Link to comment
jefe de jefes Posted May 27, 2012 Report Share Posted May 27, 2012 Do you happen to know the length of your stock one?(the half that needs replacing) Link to comment
ohmrchristopher Posted May 28, 2012 Author Report Share Posted May 28, 2012 No, would the manual have an idea or would I measure from tip to tip? I was thinking a drive shaft shop could make something for me? Link to comment
Guest kamakazi620 Posted May 29, 2012 Report Share Posted May 29, 2012 Do you happen to know the length of your stock one?(the half that needs replacing) It appears to be the rear Driveline for short bed standard cab Link to comment
ohmrchristopher Posted June 4, 2012 Author Report Share Posted June 4, 2012 Thanks Kamakazi, I acutally need the driveshaft now, the read weld yoke is cracked/worn to shit. So basically looking for a rear drive shaft now 31" from weld flange to weld flange. Link to comment
datzenmike Posted June 4, 2012 Report Share Posted June 4, 2012 I have a KC which is the same length as a long wheelbase (long bed) truck and it's 38..75" center to center of the U joints. Link to comment
EricJB Posted June 6, 2012 Report Share Posted June 6, 2012 I have a couple of aft sections from a 521. Just the rear flange, u joint, and rear shaft up to the splined end by the center bearing. Not sure if they are the same. I have no use for them. Are you going to Canby? I'm not,( I have a race on Sunday) but Might be able to get it there. Again, not sure if they are the same. Link to comment
Recommended Posts