Jester Posted January 23, 2012 Report Share Posted January 23, 2012 Looking for a free single Z24 piston that I can play with. I want to do some measuring and stuff. Gladly pay for the shipping of coarse. Link to comment
datzenmike Posted January 23, 2012 Report Share Posted January 23, 2012 89mm wide 21mm diameter piston pin 34mm from center of pin to top of piston 15cc dish Hyper-eutectic (high silicon content)aluminum. Link to comment
Boaty Posted January 23, 2012 Report Share Posted January 23, 2012 It's not every day a person publicly requests to play with their piston for free... lol. Link to comment
Jester Posted January 24, 2012 Author Report Share Posted January 24, 2012 What can I say I'm shameless. Link to comment
Jester Posted January 24, 2012 Author Report Share Posted January 24, 2012 89mm wide 21mm diameter piston pin 34mm from center of pin to top of piston 15cc dish Hyper-eutectic (high silicon content)aluminum. Now cut it in half from top to bottom and tell me how thick the top of the piston is and how thick the outside raised portion is from the top of the center. Link to comment
datzenmike Posted January 24, 2012 Report Share Posted January 24, 2012 Well the dish is 0.125" (3.175mm) deep in the middle or the raised rim around the top is 0.125" high above the bottom of the dish. The middle (thinnest part) of the dish is 0.39" (9.906mm) thick down to the underside of the piston, and much much thicker towards the outer edges even if the raised rim around the dish were removed. So there, stop your :lol: :lol: :lol: Link to comment
Jester Posted January 24, 2012 Author Report Share Posted January 24, 2012 Now I'm really laughing. Did you actually go cut one up or just pull those measurements out of your ass? Either way, thank you. That is what I was after. I may post this in wagon build thread. You can close this now if you like. Link to comment
datzenmike Posted January 24, 2012 Report Share Posted January 24, 2012 I would never hurt a piston like that! Now I'm lulz ing. No I just used a vernier caliper and a straight edge. Probably within 0.005". Nothing magical or odd about that. Of course it is odd to most that I would have a Z24 piston laying about. .... or...... is it???? :lol: :lol: :lol: Link to comment
Recommended Posts