Zeusimo Posted August 14, 2011 Report Share Posted August 14, 2011 Would I Need 3? How Can This Be Done? Do I Place Them In The Same Position They Were In? What Grease Would I Use? Never Done This Before :unsure: Quote Link to comment
Zeusimo Posted August 14, 2011 Author Report Share Posted August 14, 2011 Also What's The Seal Called To Replace Once The Shaft Is Out? Quote Link to comment
datzenmike Posted August 14, 2011 Report Share Posted August 14, 2011 Mark the drive shaft and each flange so that when the new U joint is in they go back in the same relation to each other. You will need three for the 620. U joint replacement The rear tranny seal can easily be replaced while the drive shaft is out.The Nissan part number is #32136 U0100 and is used in all 620 4 and 5 speeds after '73, 280z and zx non turbo, 720, S110 and even fits the 200sx dogleg. Very common seal and will also fit the 521/510 610/710 A10 I believe. About $8 at dealer cross referanc it at NAPA for about $5. Pry the old one out with a screwdriver, cover new one with block of wood over it and use hammer to drive it in. Using wooden dowel carefully tap it in fully. Grease the rubber lip before installing it. . 1 Quote Link to comment
south of reno Posted August 14, 2011 Report Share Posted August 14, 2011 I hate Pennzoil oils but they do have a nice Premium High Temperature Wheel Bearing 707L Red Grease.;) Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.