Grey_Matter Posted August 22, 2010 Report Share Posted August 22, 2010 i got a set and trying to figure out the proper technique, cause all the crap ive been reading online is just in fact that....crap Quote Link to comment
808DA6 Posted August 22, 2010 Report Share Posted August 22, 2010 Metal Bumping This is a pretty good read. -B Quote Link to comment
Pacific coast Datsun Posted August 23, 2010 Report Share Posted August 23, 2010 Hard to teach / give advise without actually showing somebody how to do it. If you can ever make it to my place i have a few old fenders you can practice on. Quote Link to comment
Guest DatsuNoob Posted August 23, 2010 Report Share Posted August 23, 2010 just remember baby taps, dont swing that thing like a framer :lol: Also, you should try to avoid striking the material with the dolly directly under your hammer (Datsun metal is already tinny enough without stretching the hell out of it :D)I screwed up a couple panels learning how to use hammer and dolly. I can bump out dents but I'm still no expert. Just takes alot of patience and practice. Quote Link to comment
dAty_dIvA Posted September 13, 2010 Report Share Posted September 13, 2010 .....hope you've got a long block....you might need it!! (just tap it a little...give it a lil tippity tap!! tap, tap, taparoo!!) Quote Link to comment
izzo Posted September 13, 2010 Report Share Posted September 13, 2010 just taaaaaaaap it in... Quote Link to comment
GERMS Posted September 14, 2010 Report Share Posted September 14, 2010 just taaaaaaaap it in... hilarious!!! hahaha :P Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.