metalmonkey47 Posted March 23, 2010 Report Share Posted March 23, 2010 I pulled my fuel level sender unit on my B310 because my gauge wasn't working, to find that the small wire was broken. (PIC ATTACHED) My question is, can I replace this small length of wire with any size wire, or does it have to be the exact size wire? I don't wanna risk blowing anything up. Quote Link to comment
jefe de jefes Posted March 23, 2010 Report Share Posted March 23, 2010 Try it out. Just make sure it's pretty dry before you solder or you'll catch fire and die. Or.......find yourself another sending unit. Quote Link to comment
hang_510 Posted March 23, 2010 Report Share Posted March 23, 2010 you could try soldering it... it will change the overall resistance of it, causing errors in the reading. it may not be a big deal when done. it you replace the missing section, it also needs to be the same gauge, for the same reason. Quote Link to comment
metalmonkey47 Posted March 24, 2010 Author Report Share Posted March 24, 2010 That's what I was thinking, just needed to confirm. I didn't want to replace the sending unit if I didn't have to, because I can't find one that uses the same resistance as the one I have and It's going to throw off my gauge. Thanks!! --Matt Quote Link to comment
Datsun fan Posted March 24, 2010 Report Share Posted March 24, 2010 Get an Ohm meter or multimeter and measure resistance of same wire (the same length of missing segment), I guess it should be several hundreds of Ohms, then get the same resistance wire or adequate resistor and connect/solder the tow (banks) . ;) Quote Link to comment
datzenmike Posted March 24, 2010 Report Share Posted March 24, 2010 I can't make out the picture but what I've found is that one lead goes in and is wound around a form and comes back out to a ground connection. Power from the dash voltage regulator, around 7-8 volts, travels through this 'resistanc coil', which is about 80 ohms, and this would read empty. Also the arm with the float is grounded and rubs against the bare wire coil, so the path to ground changes with the fuel height. When full, the arm is up near the top and only a small amount of coil is used, about 10 ohms, and this will read FULL. As the float drops the resistance increases and the gauge drops toward EMPTY. Because these sender designs are likely very expensive to certify as safe for use in the hazardous location of a fuel tank it's almost sure that one design is used in almost all Nissans and only the tank and float changes. When I installed my 720 tank in my 620 it worked just fine. I think it would be best if you got another sender and swapped your float arm onto it. Be sure to replace the neoprene O ring. Quote Link to comment
metalmonkey47 Posted March 24, 2010 Author Report Share Posted March 24, 2010 So I did some soldering and the unit worked for about 10 min, then it went out again. I guess I'll just have to replace it. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.