Radim

I have an MSD Blaster 2 coil on there.... and oddly enough the truck runs fine.... Started fine this morning i didn't touch anything after we got it towed last night, checked the plugs while i was at it and they were okay just a little carbon buildup... swapped them out for NGK-Irudiums, adjusted Carb, and it runs perfectly again. My brother also noticed one of the spade plugs was detached from the wire on the module... wire was still in there just a little loose... he crimped it back to the spade connector and re-attached it... The whole thing is super weird.... hopefully it doesn't happen again. Thanks for the help and suggestion guys...

Woke up and tried to start it this morning..... it started... WTF? I'll be checking fluids, plugs, and what you mentioned Hainz. Also, i'm running a Matchbox Distributor and Weber 32/36 Thanks guys!

Fuel definitely, spark not to sure, i'll keep poking around tomorrow.

No, the smell was around before it turned off, was very faint... thought it was just the car infront of me running lean or something.

You might need a new one of them turn signal relay control thing-a-majigers. LEDs sometimes cause the turn signals to flash faster than usual.... local Auto parts store should have an Electronic controller that works with them.

Oh, here's an OIC for good measure.

So my 620 finally decided to take a crap after a year and a half of running perfectly. Started up perfectly fine. I was driving to a electronics store with my brother and on the drive there the idle was really low at stop-lights, at the 2nd to last stoplight the charge light was even coming on and off cause of the erratic low idle. Finallly at the last stop light it decided to shut off, tried cranking it over and it wouldn't turn back on... there was a weird smell, not burning electronics, or coolant/oil/gas, we pushed the truck to a diner and tried to figure out what was wrong, we bought a new ignition coil and that wasn't it. So we towed it back home to the tune of 40$... :( The truck cranks super strong and if i keep the key turned to crank and gas it, the truck will "run" but not run per se, as soon as i take the key off of the cranking position to "ON" the truck shuts off......ignition switch is new. This happened after a quick grocery-get not 2hrs prior to this.... ran perfectly fine then. Any help will be greatly appreciated... i have to pick up my next shipment of stuff from Japan tomorrow and rather pick it up as soon as i can..... HELP!

Give me a call, 555-4WAT.... I'm no lawyer, but i saw it in a movie once.

Backup your information every couple of months, scan for virus/spybots frequently and don't watch too much porn.

Cell phone pic of my BMW 620 Projectors when i had barely finished installing them and used 3,000k HIDs (Now have 4.5K) they aren't probably aimed in the pic either Even with the fluted lens you can clearly see the cut-off... with the 4.5K the light output is AMAZING, rivals most new cars equipped with factory projectors.

That's a lose lose situation for both of you.

Smog stuff gone.

15x8.5 -35 all around. (No modification to fenders, perfect to run stock or lowered) Same in front, 15x10 -44 Rear (Rolled/Flared fenders front and back pretty stretched tires)

The seats are trade + Cash, if i don't get the bench seat in the trade the price will be significantly higher. I'm sure there is someone headed north, or someone that came down to SoCal.

It recirculates exhaust gasses into the intake, but i don't think you can use it or need it with the sidedrafts.

Nah, i had to drill some holes in the tab where the stock bench seat bolts in and reinforced it with some steel strips. You'll need the rails, easier to find for the fronty since you just need Recaro rails for it, but i'm sure you can mod the rails to the 521. Hehe, you're welcome Dude. Enjoy

Don't cap it, just put one of those little air filters.

You has a bench seat? :D

Tired of these seats... someone trade me!

Helios Edition VDub.

Hehehe Oh, yeah and they're adjust/fold

ttt

Kk, i'll tell him to come grab it and the rest is yours i'll call you when he grabs it.

I'll be busy today, i'll PM you later. Do you need the carb cause a buddy of mine might need it.

I'm tossing a 6 bolt L20B in it.