N0RCALDIME Posted December 9, 2009 Author Report Share Posted December 9, 2009 i'm off to pepboys. Quote Link to comment
lynchfourtwenty Posted December 9, 2009 Report Share Posted December 9, 2009 ten four good buddy.. my switch fits perfectly where the cig? lighter went.. below the wiper thing... anyway there was a perfect hole an ya.. works well.. i think it ends up bein on a medium speed tho.. which isnt too bad.. Quote Link to comment
N0RCALDIME Posted December 9, 2009 Author Report Share Posted December 9, 2009 i hath fixed the blower. now i cant remember where the hoses route to from the block? anyone have a diagram? one goes from the water pump to one side??? one goes from the back of the block to the other side??? but which goes where??? Quote Link to comment
lynchfourtwenty Posted December 9, 2009 Report Share Posted December 9, 2009 i would figure that the hoses would kinda be molded in a way that u could tell where they go.. an be a certain length ect.. but i dont have a dime so idk.. :( Quote Link to comment
lynchfourtwenty Posted December 9, 2009 Report Share Posted December 9, 2009 i would assume ones an in an ones an out.. now should the water pump push the water in? or should it draw it out?? hmmmm? Quote Link to comment
N0RCALDIME Posted December 9, 2009 Author Report Share Posted December 9, 2009 i bought new hoses recently so no markings. im not sure if it sucks or blows water. im a dummy. anyone know? Quote Link to comment
lynchfourtwenty Posted December 9, 2009 Report Share Posted December 9, 2009 this might help.. http://cgi.ebay.com/ebaymotors/Datsun-Heater-Inlet-Connector,-240Z-280Z-280ZX-NEW!_W0QQitemZ310184337079QQcmdZViewItemQQimsxZ20091126?IMSfp=TL0911262010013r35709 Quote Link to comment
lynchfourtwenty Posted December 9, 2009 Report Share Posted December 9, 2009 bonvo said: in the 610 the one by the waterpump goes the the bottom nipple Quote Link to comment
N0RCALDIME Posted December 9, 2009 Author Report Share Posted December 9, 2009 thank you to everyone who contributed to this thread. oem heater is fully functional!!!! never give up on a datsun!:) i will keep warm now!:D:D:D Quote Link to comment
lynchfourtwenty Posted December 9, 2009 Report Share Posted December 9, 2009 glad i could help man Quote Link to comment
pl521sss Posted December 10, 2009 Report Share Posted December 10, 2009 Any luck on the heater? Quote Link to comment
lynchfourtwenty Posted December 10, 2009 Report Share Posted December 10, 2009 thank you to everyone who contributed to this thread. oem heater is fully functional!!!! never give up on a datsun!:)i will keep warm now!:D:D:D ^^ Quote Link to comment
pl521sss Posted December 10, 2009 Report Share Posted December 10, 2009 sweet I knew it will work out for you We've done 3 including a 521 and they all have good heat output when cleaned out properly. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.