this is the center support bearing
mine was no good as you can see
it is about $80 for the part and an hour to replace with pulling the shaft and installing
if your going to pull the shaft do what i did and go ahead and spend the money on new hardware (nuts and bolts) and cv's
that interior just screams stock 620
love it super cool
can you just imagaine what would happen if you went to buy a new car and requested that interior
http://www.cardomain.com/ride/3865361
page 3 has the newest mod
new headlight harness to run the new headlight conversion H1 bulbs are So much brighter than the factory
well it did it again
went to school and on the way home the "new" inline replacement fuse melted and blew
so 10:00 at night driving home without any marker lights......
working on chasing down the "short" tomarrow
oh that should be fun
this is true
I was just going to do the carrier bearing
ended up replacing 10 bolts and couple cv joints
but that is the curse of owning and restoring a classic
a buddy of mine told me that with a new car you make car payments
but with an older car you just plan on puttinf the payment in to the car just as a repair bill / upgrade bill
every month
thank you dave that does help the owner before me just slammed a bunch of 20amp fuses arcoss the board and I just knew that was not right I replaced them all with 15's but i am knocking a couple of them down to the required amount NOW........thanks again Dave
BUT what do they go to ?????
I know the bottom right one is the marker lights cause that is what melted
As far as a replacement ....it may not be the factory original equipment but i am putting a blade fuse panel in its place...
just wanted to know what each of those went to .........
i have a 1976 620
one of my fuses melted away part of the block and so I patching the problem
but I have tried to find where the fuses go
I have a service manuel for my truck and a wire diagram also
but i was hoping to get a picture and or diagram of the fuse panel cover if anyone has one still on there truck
there are only 6 fuses but i still want to know where they go
Can any body help me out ???????
i am looking for a replacment antenna for my 620
its a 77 year model
or I could put a replacement in its place
anyone ever use a stealth antenna like a thin glass mounted one inside the truck
let me know your ideas
or if you have an original part...
thank all