Zachsta Posted April 25, 2011 Report Share Posted April 25, 2011 So, I've searched and searched, and the only thing I've found was someone who did a custom pan, but haven't gotten a response from him. Anyone have any solutions to the oil pan clearance on a KA swapped 510? I'm trying to figure out a way so I can go a bit lower. Raised motor mounts? Custom pan? Thanks! Quote Link to comment
Sinnful Posted April 25, 2011 Report Share Posted April 25, 2011 620 motor mounts and custom skid plate Quote Link to comment
MINItech760 Posted April 27, 2011 Report Share Posted April 27, 2011 This is the passenger side after cutting it down and re working it.[/img] this is the driver side after modifying it. http://[/img] And here's my cross member after I cut it and flipped it [/img] theres a ton of writeups on this exact subject. any of the how-to writeups pretty much cover it. search bar is your friend i had an issue i didnt see anyone mention with the exhaust flange hitting the steering gear bolt, and prevented me from bolting up the exhaust.and the brackets tweaked the hell out of the 510 mounts, they wouldnt have lasted a day before tearing off. so, i used the ka engine brackets, cut them up and modified them to fit properly on the stock 510 mounts. i figure theyre half the price of the 620 mounts, and i already had them, granted, i'll be replacing them within a couple more months anyways, but thats 20 bucks it saved me, plus it lowered the driveline enough, i didnt have to cut very much out of the trans tunnel to get the right driveline angle. and it sits nice and low, easy to get the trans out, without fighting the engine, and lowered the center of gravity too. i'll try and attach some pics of them before and after, im uploading them now. Quote Link to comment
Zachsta Posted April 27, 2011 Author Report Share Posted April 27, 2011 Thanks dude! I'd really appreciate it. Quote Link to comment
Yellowcar Posted April 28, 2011 Report Share Posted April 28, 2011 I made new brackets and used the 510 mounts. I also made a new trans mount and oil pan. and am modifying a KA header to fit. Not the best pictures but... Quote Link to comment
MINItech760 Posted April 28, 2011 Report Share Posted April 28, 2011 so yellow car, instead of modifying the cross member, you are modifying the oil pan? Did you also have to modify the oil pickup? I'm interested in knowing how much less oil it takes now, and if it could end up cavitating the oil pump during heavy load. Are you adding a sump anywhere else? Or flattening the original sump to keep the same volume? Quote Link to comment
datsun510 Posted April 28, 2011 Report Share Posted April 28, 2011 Attached are pictures of my custom pan. The stock pickup needed to be modified and the pan has trap doors to keep oil at the pickup. The pan holds more oil than the stock pan. Quote Link to comment
Yellowcar Posted April 29, 2011 Report Share Posted April 29, 2011 Mine is pretty close to the gold pan above but a little shorter to get the motor as low as possible. same thing with the pickup and doors to keep the pickup in oil. I am also going to run an oil cooler which will increase capacity a bit as well as an accusump just in case. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.