optimussr20 Posted September 15, 2010 Report Share Posted September 15, 2010 Hey! has anyone ever used mckinney motorsports products. Quote Link to comment
sssr20det510 Posted September 15, 2010 Report Share Posted September 15, 2010 what are you looking at getting??? Quote Link to comment
optimussr20 Posted September 15, 2010 Author Report Share Posted September 15, 2010 I was checking out his engine crossmember for the sr. Quote Link to comment
sssr20det510 Posted September 15, 2010 Report Share Posted September 15, 2010 its butt welded together so i dont much care for it , you can get a flipped one for 150 or i can do one like mine for 200 Quote Link to comment
optimussr20 Posted September 16, 2010 Author Report Share Posted September 16, 2010 Yeah thats what i was worried about when you start to get alot of horsepower his welds would start to crack! I have seen them in person and they dont look to bad but if his welds didnt pentrate then it would just fall to shit. Quote Link to comment
71dime Posted September 16, 2010 Report Share Posted September 16, 2010 get ahold of ranman72 i just traded my reversed crossmember too him its powdercoated gloss black too Quote Link to comment
optimussr20 Posted September 16, 2010 Author Report Share Posted September 16, 2010 alright thanks Quote Link to comment
Braden Posted September 16, 2010 Report Share Posted September 16, 2010 they must really suck if you cant get any penetration on a double bevel butt joint!!! Quote Link to comment
wana510 Posted September 18, 2010 Report Share Posted September 18, 2010 I bought a shorten sr 510 driveshaft from them and the quality and fitament was great. Quote Link to comment
datrod Posted September 21, 2010 Report Share Posted September 21, 2010 I know Mac. They do nothing but quality work. And alot of it. I think if they made shit products word would travel fast. Quote Link to comment
Datsfrodo Posted September 22, 2010 Report Share Posted September 22, 2010 Mac has done some work for me as well. Shorted drive shaft, tranny x member, redone engine x member, and even did a play and plug KA harness. All the work was top quality. No corners cut. And i even picked up the urethane engine mounts, which is the only way to go if u have a ka setup. You get what you pay for. Quote Link to comment
optimussr20 Posted September 23, 2010 Author Report Share Posted September 23, 2010 Yeah I think I will try there stuff. Like I said I seen them in person and it looks fine to me. I just wanted to hear some other opinions. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.