GT Motion Posted February 19, 2011 Report Share Posted February 19, 2011 I just ordered a new seat and seat brackets, the brackets say 510 on them but I am not sure how they will mount to the car. Here is a picture of the seat bracket upside down. See how in the back it has the tabs to bolt to the floor, but the front is just flat. Is this right? Quote Link to comment
jefe de jefes Posted February 19, 2011 Report Share Posted February 19, 2011 They aren't stock that's for sure. Should work though. You try lining them up? Tabs to the back and the flat part up front. Quote Link to comment
GT Motion Posted February 19, 2011 Author Report Share Posted February 19, 2011 They are Corbeau, I know how they are supposed to line up, I just didn't know it was supposed to be flat and bolt down like that in the front. After it stops raining I am going to check the car these just don't seem right. Quote Link to comment
jefe de jefes Posted February 19, 2011 Report Share Posted February 19, 2011 The front part of the seats mount to a rail that sits about 2-3" off of the floor board. Quote Link to comment
GT Motion Posted February 19, 2011 Author Report Share Posted February 19, 2011 The front part of the seats mount to a rail that sits about 2-3" off of the floor board. oh ok, that makes sense, the previous seats were mounted in a different location, thats what confused me. Quote Link to comment
pl521sss Posted February 19, 2011 Report Share Posted February 19, 2011 how much did it cost you? Quote Link to comment
GT Motion Posted February 19, 2011 Author Report Share Posted February 19, 2011 how much did it cost you? I bought it with the Corbeau seat I ordered, I think its like $90? Quote Link to comment
GT Motion Posted February 19, 2011 Author Report Share Posted February 19, 2011 The front part of the seats mount to a rail that sits about 2-3" off of the floor board. Am I missing some part of my floorboard then? There is nothing that this can bolt on to. No matter where or how I put this its going to look like this, just leaning forward, this is definitely not right. Its either the wrong bracket or I am missing some part/bar on my floorboard. Quote Link to comment
jefe de jefes Posted February 19, 2011 Report Share Posted February 19, 2011 Looks like someone removed yours. Use a piece of channel or square tubing as a spacer maybe? The floor isn't straight in that area though. Quote Link to comment
GT Motion Posted February 19, 2011 Author Report Share Posted February 19, 2011 Looks like someone removed yours. Use a piece of channel or square tubing as a spacer maybe? The floor isn't straight in that area though. Thanks I will figure something out. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.