Hey guys
I have seen around that some people have managed to take the d21 A arms and spindles and install then into 620s. is it possible to install the whole lot into a 73 620 running kingpins. I pretty much want the lot if possible, so drop spindles and discs. Anyone done it and can offer a few pointers?
Hey guys im new on here but have just started a datsun 620 project and am looking for a rear diff setup that will allow me to run independent bags on each side. Have been looking at s14 rear subframes because they seem to be plentiful but are way to wide for the datsun.
Anyone done this or have any ideas on something else that would be about the right width.
Truck is a 74 620 running kingpins in front and drumbrakes all round.