Jump to content

Drive shaft ID


Recommended Posts

  • Replies 3
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

From '74 through '79 the front ones should all be the same length. The rear one depends on the frame length. Short and long frames.

The '73 used a short 26" 4 speed so the front would be longer than the later 620s might even be a match for the 521 L16 .

 

Sorry, don't have any numbers.

Link to comment

Only the '70-'72 L16 PL521 had the bolt on flange on the transmission output spline. The J13 powered 520 and '69 L521 had a single driveshaft so didn't have the bolt on output because the transmission and differential have to move independent of each other.

 

The PL521 transmission is identical to the 510 wagon 4 speed including the gearing, other than this flange.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.