Jump to content

Silicone sealant between backing plate & differential flange?


jfbrink

Recommended Posts

 

So, I've finally gotten around to replacing my bad rear wheel bearings. I knew I had delayed too long when I realized I could tell how fast I was going by the pitch of the bearing whine. 

 

The driver's side bearing is full of rusty goo. It looks like water was getting in between the differential flange and the backing plate. Is there any reason that I shouldn't seal this joint with a thin layer of silicone sealant? This side has no shims. The passenger side, which still had viable grease in the bearing, has one shim. 

 

What do you all think? 

 

Jesse.

 

Link to post
  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Probably a very good idea. And always avoid submerging the differential. The hot air inside will cool and contract drawing water in the vent on the top side.

Link to post

 

Well, it looks like I have bigger problems than bad bearings. The inner race fell right off after I cut the collar free.

 

Both the axle and the spacer are heavily grooved. Anyone in LA area have an extra axle they could part with?

 

Jesse.

 

20210223_210215.jpg

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.