One six industries

[G-Duax]

People in Japan have been using crank angle sensors off the SR20 for a long time.

But you have to be able to do a little machine work to make the pedestal, and add female splines to the distributor drive shaft,

or use the splined shaft from Kameari.

 

[Spiff]

Been running an sr20det Cas in my z20e+t for over a year. Been good. 3d printed a pedestal for it believe it or not. Overall cost is probably less than half of the one six industries Cas. 

Regardless, embrace technology. Troubleshooting isn't any harder on a efi vehicle than any other, especially if you've built it yourself then you know everything about it. 

[tim510]

Hey guys,

 

I run OneSix Industries, let me know if you have any technical questions.

 

Thanks for your comments and feedback, I enjoy reading remarks.

 

As for the question of price, its Australian Dollars.  So not terrible value for USA residents. 

 

Could you make one yourself for less?  Potentially

Could you keep your carbies and single coil?  Sure, its not for everyone.

 

I've helped setup these on a bunch of cars now, as with anything there is always time required and configure, but results have been great. 

 

I've been working on a couple of new products.

 

LS coil bracket :

 

 

Cast Intake to suit Bike EFI ITB's:

 

 

I'll do my best to check in again soon and reply to any questions.

 

 

[Bleach]

Looks like some good stuff. Do you also support the L28 engine?

[alexg89]

id love to have this for the KA .. wish i knew how it was made so i could make one lol im over having a GM hei module for an ignitor 

[wayno]

I could not find the manifold for bike carbs on the site.