Jump to content

73 620 with matchbox distributor misses at high idle


Cordova Kustoms

Recommended Posts

  • Replies 11
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Many problems with what you're saying:

First, I assume that you actually have a L16 engine with, dual point dizzy?

If so:

-only use engine matching coil, i.e L16

-inspect the condition of the points

-use a feeler gauge and check for correct distance

-check the dizzy cap contacts

-check you spark plugs and make sure they are within spec

-check your ballast resistor for correct resistance

If you actually have the matchbox:

-cant help you but Im sure there are similar checkups you can do

Link to post

That would be highway speeds.

 

22100-H9701 is for a '78 through '82 Datsun 210 and 310 with A series engines. Probably converted for L series use. No worries all the EI coils are basically the same and the '79 S10 will be fine.

 

I would look on the distributor cap and rotor for cracks and carbon tracking which is a low resistance path to ground where it is arcing. It will look like a fine lightning strike zig zag across the surface. May also be on the coil to the negative terminal. Next, look at each plug wire for signs of arcing. Or just replace if you don't know how old they are. Next the plugs. At higher speeds and heavier throttle it becomes harder to fire the plugs. Use only NGK B6ES for a '73. If you have Champion or Autolite or what ever... get rid of them.

 

Keep in mind that spark ALWAYS looks for the easiest path to ground... ALWAYS. What you need to do is make that so impossible that it has to jump across the spark plug gap.

 

Last think that will cause poor high speed RPM break up is bad valves. Lets leave that for now.

  • Like 1
Link to post

Ok good I ordered the right coil at least. The cap rotor plugs and wires are probably 3 years old. I replaced when I put the matchbox in. I remember it being from a 310 now that you mention it Mike. I'll check everything tomorrow but the coil I've never replaced and it looks like it went down with the titanic. The plugs, now that's interesting. I don't remember what they are but I'll check them out. I'm a hot rod guy and seen and done just about every combination of engine and trans into every kind of car or truck. This goddamn little truck kicks my ass!

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.