Jump to content

63a dogleg rebuild kits?


Recommended Posts

  • Replies 10
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

I just bought a 63a in unknown condition and after so many years I'm sure it could probably use a freshen up either way. Cobra had it in stock with too cheap to be true pricing, its almost already here! Has anyone rebuilt one on their own? How hard is it?

Link to comment
  • 1 month later...

Great info Mike!


Obviously you don't need the puller for the rear bearing. A few gentle blows with a hammer and the bearing will walk it's way off the shaft. And a dead blow hammer will get the shafts out of the center plate bearings.


Check the thrust washers for wear and if there is any wear present, replace them or at least be sure to put them back on the way they came out, or the gears will bind when tightened back up.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.