Jump to content
difrangia

Mighty Mouse Engine Rebuild & Upgrades

Recommended Posts

Nice writeup, Steve.

 

If the ohm range is off, but reads in the same direction, a resistor can sometimes do the trick. I use a volume control from an guitar amp to help figure out the ohm requirements and then solder in the needed resistor. One of these days I'd like to get set up to rebuild gauges, at which time, I'll get one of those "pots" that the old timers use.

 

For cleaning sending units, I use metal etch. Depending on if it is rusty or just dirty. If it's rusty, it usually requires manual cleaning before the etch.

  • Like 2

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

By using this site, you agree to our Terms of Use.