Jump to content

Slipping clutch


Recommended Posts

stage 1 is 750KG which is almost overkill on a stock L20 . a stock Exedyprssure plate is fine and make the master and slave last a lot longer as its not as stressed. Esp if most masters and slave cylinders are made in Taiwan. which I cant get more than 5 years out of in daily driver mode


most times people have the wront TO bearing colar if a motor/trans  was swapped. which might ingage the pressure plate prematurely or slave rod length wrong.

Link to post
  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

It wasn't too hard to get used to but when my exhaust installer went to put it on the rack, he crawled out of the truck and said "YOU drive it up on the rack". I was tired of the stock clutchs which never seemed to live up to my expectations so I bought this one. It has done all I expected and more.

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.