derek Posted September 18, 2009 Report Share Posted September 18, 2009 (edited) I have a rebuilt L18 with less than 100 miles on it. comes with stock intake and exhaust manifolds along with the carb and everything else that bolts to the motor 250$? also have an L18 with an unknown history. also complete. with intake mani and carb. the valve cover has been removed and the valvetrain looks clean and good so the motor might be good to run as is? 100$? all prices are obo since i dont know what they are worth. Im located in salt lake city utah and buyer will be responsible for pickup or actual price shipping and ill accomodate as much as i can. i will be near mesquite nevada in a week for a bit if that helps any southern cali or vegas owners. email derekedginton@yahoo.com Edited September 18, 2009 by derek Link to comment
derek Posted September 18, 2009 Author Report Share Posted September 18, 2009 forgot to mention that the rebuilt motor comes with the 4 speed transmission. engine runs and it drives pretty decent. Link to comment
derek Posted September 21, 2009 Author Report Share Posted September 21, 2009 i was asked what heads were on them. they both have a87 heads. i dont know if they are peanut heads or what. Link to comment
derek Posted November 2, 2009 Author Report Share Posted November 2, 2009 also found two extra intake manifolds, a carburetor and mechanical fuel pump. everything is still avail. ill try to get pics of the motors this week Link to comment
derek Posted November 30, 2009 Author Report Share Posted November 30, 2009 still up. you guys figure out shipping and ill send both motors and trans and all the spares i have for 200$ spare L18 w/ a87 L18 w/ a87 & trans Link to comment
slammed521 Posted November 30, 2009 Report Share Posted November 30, 2009 i might be intrested in the runnig motor i am getting a 70 521 with no motor would this be a diresct bold in Link to comment
datzenmike Posted November 30, 2009 Report Share Posted November 30, 2009 (edited) Absolutely it would. Derek, measure across the clutch wear surface on the motor in the trunk. Is it 7 13/16" or 8 13/16"? If the former it's from a car probably a 610 or 710, if the later it's from a 620 truck. Edited November 30, 2009 by datzenmike Link to comment
derek Posted November 30, 2009 Author Report Share Posted November 30, 2009 i will measure it tonight and post results tomorrow mike. thanks for the interest guys Link to comment
derek Posted December 1, 2009 Author Report Share Posted December 1, 2009 i measured across the surface friction area. it measured just over 8" at the widest spot so im guessing its a car motor. Link to comment
Recommended Posts