Jump to content


  • Posts

  • Joined

  • Last visited

About sal

  • Birthday 05/30/1979

Profile Information

  • Gender
  • Location
    San Bernardino ca
  • Cars
    71 510 2door, 71 510 2door 2.3 ecoboost
  • Interests
    help out
  • Occupation
    Machine shop ownener

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

sal's Achievements


Newbie (1/14)



  1. sal

    510 ecoboost

    Most everything fits as if it was made for the car the only down side is the limited space for the radiators and such. Would of gone with a hydrobooster but this engines have no power steering pum.
  2. sal

    510 ecoboost

    Engine 2.3 ecoboost, trans 10 speed automatic with paddle shifters i want to have traction control too
  3. sal

    510 ecoboost

    The engine and trans are in. That is as far as I have gone, stopped there need to figure out the braking system at this point no room in the engine bay for a booster so any ideas would be greatly appreciated.
  4. newer engine in older car is ok as long as it retains all the emission components but they have to be legal engines in ca those two are a no go for emisions
  5. usually when this trans are run low on fluid they tend to scratch the bearing causing the noise. The main input shaft bearing specially, also the rear counter shaft bearing is notorious for failing. So more than likely they are both bad i tried to post pics but couldn't but if you take the front cover like the above pic and see any change in color in the metal then a rebuilt is at hand. They are really simple to fix if you have a press or large bearing extractor.
  6. Did you remove the distributor or the oil pump?
  7. The switch that goes on your pedal dude so you can start your vehicle that's how I did it there is always other ways of doing things as for the 720 accessories fitting a d21 no clue I had a truck for spares so I used everything of it. Now I just finished rebuilding the auto trans I will post pictures of the what's needed.
  8. sal

    dead 620 tranny

    That you are describing sounds like your input shaft bearing is going bad for that matter all your bearing. I just rebuilt one with the same symptoms I will try to post pictures of them latter.
  9. sal

    Need some help

    Cali smog sucks, but nice ride. Things to look for on the truck are thermostat gets stuck and it leads to overheating, freeze plugs driverside cylinder #4 check for rust and pretty much you have the rest. Overheating is the main issue due to what I mentioned.
  10. sal

    EFI z24 Need info

    Nice I would love to do the same to mine.
  11. Yes it still on I was there last night.
  12. Yes it still happens I was there last night there were some nice rides.
  13. I would like to see some pictures.
  14. Sweet ride dude. I think you are ridding on the bump stops I tried to lower my d21 the same way did exactly what you are describing.
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.