kelowg
-
Posts
1,078 -
Joined
-
Last visited
kelowg's Achievements
-
But are the 620 ones functional the same? Tho I know I'd need 620 hubs and bearings.
-
Are the 620 kingpin spindles same or close enough, to use on a 521?
-
-
Fyi,fond CHEAP source for fuel pumps. 86 ford ranger in-line pump. 30-60.00 on ebay and the like,great for spare emergency pump. Walbro works good,louder when hot out tho.
-
Yes, fine without nut. On two.piece dl,carrier bearing keeps yoke in place. The whole nut on flange was nissan overthink shit. Didnt use it past 521 production at least in usa.
-
Pretty sure speedhut can set the odometer to match old speedo number. Using the gps speedo and quad gauge, no issues after 6-7 yrs except shitty oem fuel sender.
-
Yes we r back at again at pep boys. With their permission to park in front of store. Second sat's 6-???pm
-
Sorry, dont get on here much after new layout. But yeah,we need to start this back.
-
Diagnosing Engine Fueling or Ignition Problem
kelowg replied to Cardinal Grammeter's topic in Engine
Good hear u got fixed. But if u do eventally buy a weber,BUY A REAL WEBER FOR THE REAL PRICE!! i had a knockoff weber,fell aparts. Real dgv elec choke version,choke house is whiteish in color. Black is chinese crap,so is empi. -
So gettin to 104 here in the valley, 84 over ur way, soooo headin on out northbound.
-
Still trying to figure out work bs
-
Id try pulling plug wire one at a time. One that doesnt change how it runs is a dead cylinder. So then check spark plug gap/condition and if firing with it out of head. Next ck valves on that cyl. Might try(for diag purposes) disconnecting exh coil. Then see how runs.
-
Tightening up nuts will likely break a stud off. Pull it apart wire wheel pipe and collector. Replace the hardware too. Make sure flange/ring isnt warped or bent,otherwise may not clamp right
-
Ka's bit easier to find parts and work on. But i well say sr is lighter, which might help with cornering. Ka'd the 521 and now corners like shit. Wieght only diff i can think of. 300hp if u can get it to hook up would a monster. My swap ran close to 2k with rebuilding the ka24e. its was wore the fuck out. Cheap ka's r always out there,but id always find them when i was broke
-
Havent ck'd my on call sched. So hopefully
