Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation since 07/07/2007 in Status Updates

  1. 2 points
    Thank you Ratsun for 10 years of memebership!!!! Without Ratsun forum and especially Datzenmike for all the knowledge and information on everything ive learned about datsuns, specifically my 210 it wouldnt be where its at today!!! I am grateful for this forum!!!! Today is my 10 year anniversary with Ratsun.net!!!!
  2. 2 points
    Ive been doing the Datsun thing for a long time & have learned over time....dont cheap out when fixing your truck or car...buy NEW parts to make it safe & reliable 😎
  3. 1 point
    a 32/36 weber is fine for your application that what I got a L16 with a L20 head but have a cam. Its fine. I like the manual choke version. However on hot days it can desiel(run on as the later L20s and later L motor the carbs have a anti desieling selionoid on carb to plug the idle jet. If your car /truck has this already you could het a 32/36 DGEV/IC carb as it has this selionoid with it and just use the 12volt wire from car.
  4. 1 point
    So......who do I have to buy a drink around here to get added to the Facebook group?
  5. 1 point
    You can repair the oil pan stripped drain bolt hole. Buy a Ford 18mm spark plug insert kit, it includes taps required. Only Ford, all others have tapered seats, the Ford has the necessary flat mating surface. Also buy a Toyota oil drain plug, they are 18mm. Drill and prep the worn out oil pan insert location, apply the spark plug insert with included sealant. Use the Toyota plug with some lube to install and torque the insert. Let cure, remove the Toyota plug, add a Toyota drain seal gasket [I usually coat them with Permatex number 1 sealant], insert, enjoy. You cannot just replace the helicoil insert. The original insert is "SAE semi-finished" thread. Doesn't exist in the real world. It's like a straight, non tapered, pipe thread. I repaired my RL411 oil pan this way 30 years ago, it still works and doesn't drip or leak.
  6. 1 point
    Hello Admin. Thanks for allowing me in. Hope to start with your recommendations to learn the basics first. I will do my diligence with what you shared and I will be prepared for my submitted topic once completed. Thanks again.
  7. 1 point
    I can't seem to figure out why I don't get notifications for new replys to threads I follow...?
  8. 1 point
    Quite impressive dedication and enthusiasm! Kudos to your relentless and ambitious progress too!
  9. 1 point
    Hey, was hoping to get some details on your xl70 build
  10. 1 point
    Hey gene. This is Lance from Albuquerque the. I need a l20b pulley. Call me at 505-331-0650.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.